Jump to content
Why become a member? ×
  • advertisement_alt
  • advertisement_alt
  • advertisement_alt

Best £45 you will ever spend.


neilb
 Share

Recommended Posts

[quote name='stevie' timestamp='1330255541' post='1554584']
So these things work on concrete floors when the speaker cab is on castors. What principle is involved here? Has anyone carried out any before/after measurements?
[/quote]
Yes, after measurements = your cab is approx 2.5" higher than it was before standing it on a Gramma :happy:

Link to comment
Share on other sites

[quote name='stevie' timestamp='1330255541' post='1554584']
So these things work on concrete floors when the speaker cab is on castors. What principle is involved here? Has anyone carried out any before/after measurements?
[/quote]

Well the principle involved is that vibration that would normally travel throught the cabinet and be transmitted through the surface that the cabinet is sat on is significantly reduced.
That's been a particular problem for bassists playing on hollow stages for many years.
As castors have less surface area to pass that vibration to the supporting surfaces, standing a cab with castors on a Gramma pad increases the isolation even more.

Playing on a concrete floor prevents that 'boom' but you have to tweak your tone controls to get a full bodied bottom end again.

What the Gramma pad does is to use soundproof foam (which is what Auralex have made for years) to essentially isolate the cabinet from the supporting surface and give a far more consistent 'tone'.

There probably have been measurements to equate this in scientific terms but I've not bothered with them - it just 'works' and I'm happy with it. :)

Link to comment
Share on other sites

[quote name='paul_5' timestamp='1330287238' post='1555304']
My cab's on castors and standing on a small, hollow stage. I went for the alternative option of filling the cavity under the stage with old duvets etc... it worked for my drummer ;)
[/quote]

How many duvets did you manage to get him to swallow in the end, or did you use the sink plunger and rubber glove method? ;)

Edited by icastle
Link to comment
Share on other sites

[quote name='waynepunkdude' timestamp='1330274265' post='1554992']
It's snake oil for the easily influenced.
[/quote]

I'm an advertisers worst nightmare - I'll question anything and everything and then walk away from their product either because I don't believe the responses or because I'm bored with discussing it with them.

I was extremely sceptical until I tried one, but they really do make a noticeable difference - not one of those 'my bass pots are rolled on the naked thighs of young virgins on the night of a full moon' type things either. :)

Link to comment
Share on other sites

I checked the manufacturer's demo, which is interesting. Without the pad, the guitar has noticeable, and not very pleasant, distortion. With the pad, the distortion has cleaned up and the guitar sounds cleaner. Hey ho. The pad reduces distortion as well? And why did the guitarist fiddle with his volume knob while they were adding the pad?

And another thing: the OP says the pad made a large difference when playing on a concrete floor. I have no doubt he believes it did, but perhaps someone could explain to me how the airborne vibrations from the bottom of a cabinet could cause several tons of hard, poured concrete to audibly resonate.

Link to comment
Share on other sites

[quote name='TRBboy' timestamp='1330346908' post='1555914']
These look really interesting. I've measured my Markbass rig and it would be just a little bit bigger that the Gramma Pad; does anyone know if this would cause a problem?
[/quote]

The large version should have fitted ? If not buy 2

Link to comment
Share on other sites

[quote name='Dave Tipping' timestamp='1330271909' post='1554952']

.. last I heard the going rate was £10 a h-job £15 a blowy and £20 the lot .. so possibly.
[/quote]

Can you give me an address or more details. !!!! LOL
(i can't get the smiley faces to attach to the thread - must be a work thingy )

Dave

Link to comment
Share on other sites

[quote name='dmccombe7' timestamp='1330348430' post='1555939']
Can you give me an address or more details. !!!! LOL
(i can't get the smiley faces to attach to the thread - must be a work thingy )

Dave
[/quote]

http://maps.google.co.uk/?ll=56.466082,-2.957771&spn=0.001199,0.002411&t=h&z=19 ... they stand on the corner of Blackscroft and Peep O'Day lane .. pretty much every night. It's known locally as "sexy street".

Link to comment
Share on other sites

[quote name='Dave Tipping' timestamp='1330349457' post='1555966']
[url="http://maps.google.co.uk/?ll=56.466082,-2.957771&spn=0.001199,0.002411&t=h&z=19"]http://maps.google.c...002411&t=h&z=19[/url] ... they stand on the corner of Blackscroft and Peep O'Day lane .. pretty much every night. It's known locally as "sexy street".
[/quote]

sounds like a bargain :lol:
now where is Dundee :D

Dave

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...