PaulThePlug

Dunno what they should look like, but looks like they fit, or have been modded to fit ala Strat - Secured on the underside of the pick guard, with 2 screws thru for hight adjust, rather than screwed to the body ala P or J. Maybe the silicone and plate was to try and hold the windings in the covers, rather than foam under Must admit i was surprised when i realised that P pups were not fitted like a Strat, as that is what i came across first.

Mornin... Do you want to turn that down a touch... 'tis early... 😉

Expensive, albeit a very nice Parts-Bin Special. The Options and Build Guide makes interesting reading. I'm sure @Andyjr1515 could custom veneer a J body... I likes Quilted... then Fender Hi Mass Bridge, Bell Plate, Tone Riders or Kent Armstrongs - I'd go PJ 😉

Frog Chorus Reprise...

Nice... The Hipshot bridge looks so sleek The Rickenfaker site may also have some ideas on aftermarket parts. Maybe Gig Ink for a scratchplate.

Loves an Ibby SR... Fave Bass Early SR600 with the Mk1 Barts - Reverse P Soapbars Current SR600 with Mk2 Barts - Humbuckers Presume your SR400 is PowerSpans or the Arch-Top Curved Humbuckers? If you have a 'pre-prob' maybe try em Passive... or... My Modded SR300 Let's have some frets pics - see how worn they look?

Caught Stealing - Jane's Addiction

Presume you mean MN rather than No Load? My experiance with Bourns pots is the larger Dia on the threaded shaft, had to enlarge the hole on my SR600 I've used these in anything with 2 pickups... https://www.ebay.co.uk/itm/314752125906?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=bflzq06tszk&sssrc=4429486&ssuid=daj_hJ6fSo-&var=613264511655&widget_ver=artemis&media=COPY 250k for Single Coil PJs and 500k for the Twin Coil DiMarzio Jazz and Maida Vale Stacked Jazz...

Green (Labra)Door - Shakin' Stevens

SWR are touted to have a HiFi sound. But, I still haven't got my 'Washing Machine' working...

Can you remove 4x valves for halfish the wattage, and use more of the Character of running the other 4 hotter?

Maybe a Ric... Something different, maybe a Cheyenne or Laredo?

Sounds(!) familiar... (still needs lookin at)

Can't see the Pic mate? 😉 Jane i think... Similar story with replacement White Knobs for my MB Series Combo... A*

Aha! @mrbacco before you make the hole for the Jack 'Boat' in the front... have a think about having it fitted to the control cavity plate at the rear... plug could Angle Out and Downwards 45Deg-ish or out to the but or strap pin.. and not get in the way... sleek as sleek thing! 😉

Could it be so Flat heel 51 necks and Rounded Heel later necks both fit the same pocket rout... With the scratchplate covering either the middle or the L&R edges?

Do these count?.. Got one of each

Go on... How much?.. Dreadful!

Didn't bother... un-soldered the cap a pliered/shook it thru the hole.. Soldered the new cap on the underneath of the board... loads of room... 🙂

So you have had the Tort plate off a couple of times, and not replaced it? 😉

Shallot the Harlot - Iron Maiden

QUACK...