All Activity

Big bottom? Talk about bun cakes my girl’s got em! sorry…. Couldn’t resist…

This box has a set of three Speakon connectors wired in parallel (using pins 1 & 2) so can be used as an extender for speaker cables, or to allow two cabs to be driven from the same amp One connector at one end and two at the other end The box is made from very solid extruded aluminium

LA Audio high quality active DI box, very solid construction; comes with an instruction leaflet - which is worth reading since the box is deceptively versatile! This works off an 18v rail so can cope with high or low level signals. Power via phantom from your mixer or 2 x 9v batteries Usefully it has a +20db switch to increase the level of low output devices and with 1M ohm input impedance is compatible with piezo pickups The Input will work with Instrument or Speaker levels ('Pad' switch is for speaker level), isolated XLR output for your mixer and a 'link' output to take the signal on to an amp or cab A separate unbalanced output is available as well as the balanced XLR

Excellent solid and versatile active DI box from Canford Audio, only selling since I have three of these It comes with the instruction leaflet Inputs for Instrument or Amp output. Output jack for Amp input or speaker cab alongside. Balanced XLR output to mixer on the reverse. Instrument input 1.8M ohm impedance - so no loading of amp input or pickups Phantom powered off the mixer XLR or by 9v battery

A useful single channel line level isolating transformer for removing hum loops from PA, Mixer etc in a very solid metal case Input on either XLR or 6.3mm Jack - balanced or unbalanced Balanced output on XLR or 6.3mm Jack Switches for ground lift and phase reverse. The third switch provides either unity 1:1 or a 2:1 ratio tap for long cable runs There is a small circuit diagram on the top to remind you what all the connectors and switches do! Quoted frequency range is 20Hz to 25kHz at line level Dimensions 120 x 44 x 90 mm

This is a very tough, but relatively lightweight (7kg) 4U rack case. Very solidly built, with two butterfly catches to hold each end piece in place and moulded, recessed handles There is a shallow version, but this is the deeper one with 46cm between the front and back rack strips (just over 50cm front rack strip to back of case) Overall external size is 55cm wide x 23cm high x 61cm deep Rack screws included Pickup from Uxbridge area, or I'll courier 48hr for £13

I bought this very well upholstered Gator gig bag (current retail £135) for my Guild Starfire bass, but although it fits, its a bit tighter lengthwise than seems sensible, so this has barely been used. It is fairly obviously sized for a Gibson 335 guitar, but will also fit a flying V or a short-scale bass that's a fraction smaller than a Starfire Loads of padding, loads of pockets and a waterproof cover (in pocket 6 on the back, I think - depends how you count the pockets) The padding at the base of the bag can be removed (its on velcro) to give a couple of cm extra space - the quoted overall internal length is without this extra padding fitted Pickup preferred, but I will post it, although I haven't worked out what that would cost, let me know if you're interested and I'll get a price. Internal size: Overall Length: 46.1" (117.09 cm) Body Length: 25.0" (63.5 cm) Body Height: 3.5" (8.89 cm) Lower Bout Width: 17.3" (43.94 cm) Middle Bout Width: 15.4" (39.12 cm) Upper Bout Width: 13.0" (33.02 cm) Exterior Dimensions: Length: 47.8" (121.41 cm) Width: 18.3" (46.48 cm) Height: 6.9" (17.53 cm)

👍