Acebassmusic

SOLD

I couldn't find the original site either! Heres a link to another "Nordstrand" site.. [url="http://ristolainstruments.com/nordstrand/faq-support/"]http://ristolainstruments.com/nordstrand/faq-support/[/url] Scroll down to the Preamp Schematics and pick "Kitchen Sink 3b Installation"

For Sale - Nordstrand 3B-5A 3 band on board preamp. Controls consist of 5 knobs and 2 switches (switches can be removed from system) - treble, mid (pull to change frequency), bass, blend, vol (pull passive). I had the pre amp in my W&T and had the 2 switches wired to the pickups for are for series / parallel. If you don't have holes for the switches you can remove them and wire the pickups direct to the preamp. There are wiring details on the Nordstrand site. [color=#58596B][font=Helvetica, Arial, sans-serif][size=3][size=4][color=#000000]Overall gain is +/- 10db by a trim pot on the circuit board[/color][/size][/size][/font][/color] [color=#58596B][font=Helvetica, Arial, sans-serif][size=3][size=4][color=#000000]Bass +/- 12db @ 50hz[/color][/size][/size][/font][/color] [color=#58596B][font=Helvetica, Arial, sans-serif][size=3][size=4][color=#000000]Treble +/- 12db @ 4khz[/color][/size][/size][/font][/color] [color=#58596B][font=Helvetica, Arial, sans-serif][size=3][size=4][color=#000000]Midrange +/- 12db@1khz[/color][/size][/size][/font][/color] [color=#58596B][font=Helvetica, Arial, sans-serif][size=3][size=4][color=#000000]9 volt system[/color][/size][/size][/font][/color] [size=4]New[/size], one of these would cost £205 and I am looking for £110.00 plus shipping. Heres a few pics of the preamp in and out of the bass.

For sale - A matching set of Nordstrand NJ5FS 5 string jazz bass pickups in Fender size, 100mm neck, 105mm bridge. Excellent condition. I have had them in my Jazz FMT which I have now returned to the normal SCN pickups as I am selling it. These are hum cancelling split coils and would cost £210 new. I am looking for £100 plus shipping.

Withdrawn from sale - a matchi[size=4][font=arial,helvetica,sans-serif]ng set of 5 string Kent Armstrong K5 pickups. These have a lovely warm and rounded tone to them. They contain full-length bar pole-pieces allowing a wide variety of string spacing. The widely spaced coils sample a fairly long section of the string, giving a high-tech but not twangy bass sound. The 4 conductor wiring allows coil splitting, series/parallel, phase inversion etc.[/font][/size] [font=arial, helvetica, sans-serif]Dimensions are 40mm wide 110mm long and 18mm deep. [url="http://www.kentarmstrong.com/pages/products.html"]http://www.kentarmst...s/products.html[/url] [/font]

Both sold :-)

PM'd

A bass like this is worth the price of a cheap flight to pick it up

I am assuming you have 2 x Hydrive 410 (1000 Watt @ 4 ohm) In bridged mono mode the QSC only uses Chan 1 and provides 1600 watts @ 4 ohms & 1000 watts @8 ohms. You could run a bridged speakon cable from Chan 1 of the amp to your first cab and then a standard speakon from Cab 1 to Cab 2 (daisy chained). This would give you the full 1600 watts at 4 ohms. The sound would be mahoosive! Hope that helps

Just as it says in the topic, I have 2 rack cases for sale. Each of them is in good condition with all latches and handles working. Postage cost from Aberdeen would depend on where you live. I may be able to deliver locally. 4 Unit case made by CP Cases - [s]£40 [/s][color=#ff0000][b]£35[/b][/color] 4 Unit case (extra deep - great for cable storage) made by Freestyle - [s]£40 [/s][color=#ff0000][b]£35[/b][/color] ....or both for [s]£70 [/s][color=#ff0000][b]£60[/b][/color]

[size=5][color=#ff0000][b]Now Sold[/b][/color][/size] For sale (or possible trade!) is my USA Fender Jazz V American Deluxe FMT (flame maple top). Its shown in the original pics below fitted with Nordstrands and a Babicz bridge. I have now changed these out to the original BBOT and SCN (single coil noiseless) pickups which I have shown in the new pics. The Nordstrands are on sale here on the forum. It comes with the Fender hard case. All in very good condition. I have good feedback – links are in my signature. Serial number is DZ4002161 which can be checked out as manufactured at the Corona plant in 2004. Neck is bound rosewood with inlay blocks and the pre amp is 18v active. The sunburst isn’t quite as bright golden as the photos suggest but its still darn pretty! String spacing is 18mm at the bridge and the nut is 48mm. I have just noticed that there are 2 screws missing from the tuner (these dont seem to affect operation). However I will be getting in touch with Schaller to get replacements asap. See link here : [url="http://basschat.co.uk/topic/230711-fender-jazz-machine-heads/page__fromsearch__1"]http://basschat.co.u...__fromsearch__1[/url] I have now dropped the price from £1150 to [color=#ff0000][b]£990[/b][/color] for the bass and case plus shipping. New photos: Heres a couple of photos I took late last year. .