All Activity

Welcome Jonathan.

Nine Lives - Aerosmith

My uneducated guess is some connection desperately needing Deoxit. I would put cables to both FX loops, and if there are any other similar connections in the back (pre/power), put a cable there, too. If this doesn't help, the next place could be input jack solderings to the PCBA. After that the next steps would be all connections between boards, pots and so on. Deeper and deeper.

Latin Vibes! Dadi Carvalho is a bassist and multi-instrumentalist from Brazil. By age 20, Dadi was already touring the world with Jorge Ben. Jorge Ben - Hermes Trismegisto Escreveu | Dadi

Just bought a short scale jazz off Benedict, really helpful, great communication, packaging was brilliant 10/10

In Glorious Times had been suggested - but liking the deletion of an unnecessary space!

Today it is "Unf*ck The World", by Prophets of Rage.

No idea what model this is but it's definitely a schecter bass. I know he was a long term user of Washburn and Jackson basses

I'm not keen on the looks of singlecuts [1], although I do have one - a Barcus 6-string fretless that was feeling unwanted at a Gardiner Houlgate auction, so I took pity on it. Very nice to play, and the top unhorn slopes to the neck rather than being one of those (like the Ibanez above) where the unhorn slopes back towards the bridge giving it a Snoopy nose. Other than the looks, there's nothing really to differentiate this from other basses. The neck is very playable, it sounds good. [1] Except Les Pauls, though I'm not so keen on the basses

How about Inglorious Times, or (In)Glorious Times? without getting too political it's widely acknowledged that we're at tipping points of many descriptions, and most of them are the result of inequality and division.

Added to playlist!

how hot does the iron need to be? also, it's fretless, will I burn the fingerboard wood? Can I put a cloth over the board to help

For me the difference has been the need to adjust the bridge height, while swapping from a set to another (GHS and D'Addario). Soundwise I cannot say anything reasonable: when changing an old set to a new one, the sounds are so different. But how about trying two new sets?

I would really try to find a older used CMD121p Combo, I went down this route for a long time before I moved to an ampless setup , The cmd121p is perfectly loud enough for a 50-100 person gig... at perfectly giggable stage level volume with just the combo part ... but you can send a XLR line out to the PA for even more volume ... Or add any cheap ... or matching cab later down the line to use the full 500 watts of the Little mark head unit. I'm not sure what they are going for used these days £350 - 400 ? But would foot the bill

I've removed boards before via heat Steam/iron pretty much this method Take your time and work on a small section, Do not force or try to pry the board away from unheated/glue melted sections, you have about 2mm of wood under each fret and the board will snap if you try and force it You might need to reroute the rod channel if you can't find a direct fit replacement dropping a dual rod in it ok & you should be able to clean up the neck/board for re gluing with a little acetone/nail polish remover, use a blade edge to scrape it away (don't dig in) a wipe down with clean water (don't let acetone soak if it's a lam neck it might weaking the glue joints) One thing you might want to try before your go for taking the board off is to get some heat directly on the rod's nut by applying the tip of a high watt soldering iron to it, that might be enough to break any corrosion/bonding between the nut/rod (that is if it isn't cross threaded) Good luck

I’m not well today so not working and watched that between dosing in bed - it was really good