dodgnofski

Fab, thank you 👍👍

Thank you 👍 - I think there are only two wires on the replacement one - like the original, I’m just wondering if I can switch the connectors over, or if I will need to connect the new cables to the old ones and therefore retaining the original connector 😳? Than you again for your help 👍 Cheers, Tim

Thanks Guys 👍 The fan noise is only a tad to loud when playing at home, or in the studio. Live it wouldn't be a problem - however, on close inspection the fan does look like it's probably done a few sorties too many 🙈. I have been using it for most of the day with the fan disconnected and it didn't even get warm 'at home' volume & as my next Gig looks like being on the twelfth of never, this could be a temporary fix? Obviously, I wouldn't risk using it at live (fat chance) volume without reconnecting the fan. I have ordered a fan which has similar specs to the original, but has a different connector - which will test my minuscule electrical capability to the limit, I can feel a wire splice in the offing as I don't even know if the connectors can be swapped? Thanks again for your help and advice Guys, it is very much appreciated👍👍 All the best, Tim

Measurements as best as I can tell with my old eyes are :- 60mm x 60mm 15mm deep Hole centres are 50mm apart or 70mm diagonally and there is a red two pin connector at the end of the two wires. Thanking you in advance for any help, or info 👍 Cheers, Tim

oops, sorry - I’ll measure it tomorrow. Here’s a pic if it helps 👍

Does anyone know of a whisper quiet fan to replace the one in my Eden WTX264 which is a tad too loud please?

Bought a great amp from Andy - he was an absolute pleasure to deal with and therefore I would heartily recommend him to all BC'ers without - in the words of Mrs. Slocombe - fear of contraception 😂😂. All the best & thanks again Andy 👍

Thank you 👍👍

Hi Chaps, any opinions on wether or not these neck pockets indicate original finishes, or possible resprays? They are a 63, a '61 and a '65 - which shows the bare wood from where the paddle was fitted during spraying which I always thought usually indicated an original finish, but not sure if the same method was used on earlier Fenders? - thank you👍👍

I bought a Fretless from Neil and once again he was an absolute pleasure to deal with so needless to say (but I will), that once again I would whole heartedly recommend him to all BC'ers - without fear of conraception - as Mrs. Slowcombe would say 😂. Thanks again Neil, very much appreciated 👍👍 All the best, Tim