Beedster

So the O/P's question should be 'new, vintage or bitsa'

But yes, if you know what you want in a Precision, then a bitsa self-build is the way to go, and often cheaper than buying a whole bass. The below is my keeper instrument, OK I've come close to selling a couple of times due to COVID cash flow issues, but having survived it remains my go to bass. It's like a Fender Custom Shop Tony Franklin Relic, although slightly more resonant than was my original TF (courtesy largely of a VERY good Warmoth neck with perfect ebony board and shallow depth 44mm nut which has made every bass on which it has been installed resonate for longer), Lollar PJ set, Kiogon harness, vintage Gotoh lollipop tuners (the aesthetics of which for some reason I really like), all for around the cost of a used MIM Precision. As per some of the comments above, basses are a lottery, with bitsas you just keep playing the lottery, albeit with components as opposed to instruments, which is a lot cheaper. It's also far more diagnostic/scientific, because with each switch you're in effect conducting a controlled experiment along the lines "what difference does switching this for this actually make?'. You get there eventually, it's fun but you also, I believe, end up with a bass that you feel closer to as the result.

There'll be another along soon I'm sure folks

That would fail a primary school design project

How to get sued by three bass manufacturers?

Funny how we all go on about Mesa, Ampeg, and even Marshall, as well as so many others, yet WEM rarely get a mention on this forum, despite the tone being lovely and as you say Jack, their tube amps being rather good at being heard despite their conservative power ratings

Good shout mate

Yep, I totally get that as well On reflection the mistake I made, despite doing a whole lot of research into the best kit for my money, was believing that e-drums were going to be a low noise solution for rehearsing and recording traditional drum sounds (jazz, rock and blues). This was in part because none of the genres in question require either an especially 'big' or non-traditional sound, but also many drummers I'd like to have used them to rehearse/record simply did not like playing them.

That is true, one of the reasons I sacked my e-kit was that to get the best out of it for anything other than headphone use it ended up being as loud as a normal kit; too little amplification (or poor quality amplification) meant you heard the noise of the kit above the noise of the drums if you get my drift. I always felt that whilst with a real kit noise of kit and noise of drums are synonymous (possibly wrong word there), with an e-kit the two were often at odds. I didn’t explain that very well

Re monitor I used the Roland PM3-V which despite being VERY heavy is small, does a great job with kick even at low volumes, and has two HF monitors. I never giggled with it, but it would be up to the job for small events. I also use it is a bass amp occasionally. Russ, I’d sell you mine but it would cost a fortune to courier

I emailed PJB direct a few years back, got a reply within a few hours from a tech guy and when that didn’t resolve the issue Phil himself joined the conversation. Very impressive, so I’d suggest that route perhaps?