SpondonBassed

You are speaking about drilling a socket hole. In that case you are drilling. I am talking about the first part of the job which was to enlarge the cut-outs for the PU's ears, if you will. You can't enlarge a part of a hole with a drill bit and not have problems with wandering and chatter. You need to replace the material that was removed where the body of the PU sits adjacent to the ear cut-outs then drill and enlarge a whole hole, if you get me, not part of one. Hope this helps clarify my awkward wording.

I've been thinking about this. (Brace yourselves) You may find that it is impossible to keep ANY sort of drill bit true to its centre mark without you first bond a piece of similar wood in to restore the other side of the notional hole that you are about to enlarge*. Of course, you have to remove it after but it would be worth considering if you go that route (Not an intentional pun. Never mention it again please). *Edit: You'd need the inserted piece to fill the existing cut-out too of course. This gives you a surface that is flush with the top and a fresh start for the new, larger, drilling.

I have aeronautical engineering licences for commercial jets and their airframes but I ain't about to make a custom 747 for myself. Don't sweat it.

I'm planning one for myself. I'm an amateur builder though. It might take some time...

Just as a guide to what some of the jargon means: UK terminology is similar but this image was handiest to use at the time of writing. One thing worth saying before someone shouts "Dremel!" is that you should not attempt to use a Dremel unless you are well experienced with how it can kick. That way you should not end up with a notch in your curve (man).

I thought I was answering a cry for help but there you go.

I've heard of a keyboardist searching for that lost chord but to lose a whole keyboardist...? Well that's just careless.

You might find this topic haddockuate then.

Welcome Lizzy. As Dood says, it looks very much like a hack.

Enter the boffin zone... I'm loving the initial sketch. It flows well.

Welcome JL.

That's an interesting school of thought... Dang!

Welcome Newwiekins.

Welcome Mada.

Welcome Bernie.

A favourite of mine is the Build Diaries.

Welcome Andy.

Praise be to cod.

Welcome Marvin.

Welcome Eloo.

Welcome Philip.

That's worthy of the famous quotes thread.

Welcome John.

...and it only took nine asterisks! Are you knocking out four legged tripods on the side? But yes. This is a white knuckle bit. I'm bracing myself.