Suburban Man

This Fender Rumble has only had light use in our local church as a bass monitor, so in excellent condition. Comes with a Roqsolid cover and mains lead. The v3 Rumbles are surprisingly lightweight (the 100 a fraction under 10kg) but also versatile in terms of sound with three Eq presets as well as four way tone control and an overdrive circuit DI output on the rear, together with Fx loop in and out, Aux input, Headphone output, Footswitch for overdrive... 100W (RMS) with a punchy 12" speaker makes it a very portable combo for small gigs or for use as a stage monitor Ideally pickup from Uxbridge, but DM if you want to discuss a handover somewhere...

Price includes postage

Fifteen page booklet with bass lines in various tempos and genres eg Straight Time patterns, Latin Rock, Reggay (sic) patterns, Fills, 5/4 and 6/4 studies...

This is a very tough, but relatively lightweight (7kg) 4U rack case. Very solidly built, with two butterfly catches to hold each end piece in place and moulded, recessed handles There is a shallow version, but this is the deeper one with 46cm between the front and back rack strips (just over 50cm front rack strip to back of case) Overall external size is 55cm wide x 23cm high x 61cm deep Rack screws included Pickup from Uxbridge area, or I'll courier 48hr for £13

Excellent solid and versatile active DI box from Canford Audio, only selling since I have three of these It comes with the instruction leaflet Inputs for Instrument or Amp output. Output jack for Amp input or speaker cab alongside. Balanced XLR output to mixer on the reverse. Instrument input 1.8M ohm impedance - so no loading of amp input or pickups Phantom powered off the mixer XLR or by 9v battery

LA Audio high quality active DI box, very solid construction; comes with an instruction leaflet - which is worth reading since the box is deceptively versatile! This works off an 18v rail so can cope with high or low level signals. Power via phantom from your mixer or 2 x 9v batteries Usefully it has a +20db switch to increase the level of low output devices and with 1M ohm input impedance is compatible with piezo pickups The Input will work with Instrument or Speaker levels ('Pad' switch is for speaker level), isolated XLR output for your mixer and a 'link' output to take the signal on to an amp or cab A separate unbalanced output is available as well as the balanced XLR

This box has a set of three Speakon connectors wired in parallel (using pins 1 & 2) so can be used as an extender for speaker cables, or to allow two cabs to be driven from the same amp One connector at one end and two at the other end The box is made from very solid extruded aluminium

I bought this very well upholstered Gator gig bag (current retail £135) for my Guild Starfire bass, but although it fits, its a bit tighter lengthwise than seems sensible, so this has barely been used. It is fairly obviously sized for a Gibson 335 guitar, but will also fit a flying V or a short-scale bass that's a fraction smaller than a Starfire Loads of padding, loads of pockets and a waterproof cover (in pocket 6 on the back, I think - depends how you count the pockets) The padding at the base of the bag can be removed (its on velcro) to give a couple of cm extra space - the quoted overall internal length is without this extra padding fitted Pickup preferred, but I will post it, although I haven't worked out what that would cost, let me know if you're interested and I'll get a price. Internal size: Overall Length: 46.1" (117.09 cm) Body Length: 25.0" (63.5 cm) Body Height: 3.5" (8.89 cm) Lower Bout Width: 17.3" (43.94 cm) Middle Bout Width: 15.4" (39.12 cm) Upper Bout Width: 13.0" (33.02 cm) Exterior Dimensions: Length: 47.8" (121.41 cm) Width: 18.3" (46.48 cm) Height: 6.9" (17.53 cm)

Anyone need a PA amp? Usual excellent Crown quality, this amp has only had light use and comes in a Chord carry bag. Not sure what the total weight is, but the amp on its own is under 4kg, so very portable XLR inputs, Speakon outputs for most users, plus various other options as per photos As well as standard Stereo, the amp can be configured as follows: Crossover Mode (CH1=LPF, CH2=HPF) – this mode enables a LowPass Filter on Channel 1 and a HighPass Filter on Channel 2 at the frequency chosen. LowPass Mode (CH1=LPF, CH2=LPF) – this mode enables a LowPass Filter on both Channel 1 and Channel 1 at the frequency chosen. HighPass Mode (CH1=HPF, CH2=HPF) – this mode enables a HighPass Filter on both Channel 1 and Channel 2 at the frequency chosen. You can also put it into 'Bridge' mode for seriously high levels of output (according to the spec 1.5kW into 4ohm) Pickup from Uxbridge area, or I'll courier to you at cost.

Like it says on the box... Five DVD's taking you through basslines for 20 Worship Bass songs Cost includes postage

Clearing out 'stuff' I found this, which is a good quality collapsible K&M stand, but I trimmed the cross-piece to suit the width of a Hohner B2A bass, so when open it is only 14cm across the two legs If you have one of those, or a similarly small bass or guitar, then this is for you!

A bit of theory plus over 100 pages of bass lines in different styles with tabs as well as standard notation. Excellent condition

Excellent music theory book, very good condition

'The life and music of the legendary Bassist James Jamerson' - in case you didn't know Lots of info, lots of tracks. Audio is accessed via online code on the first page of the book - which should still work!

High quality transformer balanced passive DI box from EMO Inputs for Instrument, Line or Loudspeaker and balanced, isolated output to mixer Instrument input has a parallel output to go to your amp Loudspeaker input has a parallel output for the speaker cabinet

Ok, its for one of those six-string things that play an octave too high, but someone might want one... Postage £3.50