Neck bolt inserts

[The Burpster]

Has anyone taken the standard neck ‘bolts’ which are really woodscrews and  replaced them with proper bolts and inserts like Montys or Nek tite?

 

I like proper engineering and whilst I know the woodscrews have been used for decades but these products claim to increase sustain and tone. 
 

i like the idea I could torque them identically. 

Thoughts? 

[PaulThePlug]

Dunno about increase sustain or tone... but i likes the engineering approach.

 

Although the internal threaded part looks quite short... but the height of a nut i spose.

 

I'm sure there are such things available from Spaldings (who i use for Stainless Dog Point Grub Screws for Bridge Saddles) or other Fastner shops.

Edited 11 hours ago by PaulThePlug

[BlueMoon]

If it is a bass that you have to regularly adjust the truss rod (assume neck heel Fender type), then yes. I have neck inserts on a bass where that was the driver. Fairly easy job for a competent DIYer. As @PaulThePlug said, I didn’t notice any difference in sustain or tone though.

[MichaelDean]

I did it on a Harley Benton tele I owned. I felt like it made it more resonant. No scientific measurements were made though!

 

Easy enough to do with a hand drill. Just make sure you go deep enough for the threaded insert and then use a countersink bit to just bring the edge down a little before putting the insert in. 

[police squad]

are the inserts glued or pressed in, or both?

[MichaelDean]

39 minutes ago, police squad said:

are the inserts glued or pressed in, or both?

They were screwed in on mine.

[BlueMoon]

53 minutes ago, police squad said:

are the inserts glued or pressed in, or both?

Depends. The ones I used were screwed in. For extra security I put epoxy on the threads and in the cavity as well before final tightening.