How was your PA last night?

[Chienmortbb]

On 18/11/2025 at 15:28, synthaside said:

Last night ... " well saturday" ... our PA failed , We had to spin our  Monitor round and crank it to make up with it ... as a Fully ampless band this was a bit of a disaster.

The right side of the Mackie Industrial  ART 200A  would not transmit any sound from the main speaker ...  the Horn/Tweeter was producing sound confirming that  it wasn't a power issue or a mixer send issue , I confirmed  this swapping it and in my post mortem testing sunday ... when i cracked it apart hoping to find a simple issue like a loose terminal connection and within my cack handed ability to mend.

Sadly is seems one of the EQ block's is soggy / rotten 😐

Annoying ... but we've had to rush order a new EV PA ahead of next weekend's gig , the band voted with their wallets after being let down by used gear.

 I have found the circuit diagram for this speaker, and it uses fairly conventional analogue circuitry.  It is not a high-powered speaker, using three LM3886 amplifier chips, two for the LF and one for the HF. I have to say that Mackie run this chip very close to its maximum voltage unless the LF speaker is 16 ohms. Happy to have a look at it if you like. IMHO, useful as a monitor, but not FOH. 

[jimmyb625]

On 21/12/2025 at 16:01, Steve Browning said:

I went for the TS312s on foh and 310s for monitoring. On larger gigs we add a 312s sub.

That's the same setup I used to have (except for the 310's). It's a great rig for the price.

I eventually got hold of a 315s as there was a b-stock item going for a ridiculous price (£120 off the top of my head). It's good, but definitely not as easy to move around as the 312s.

[Al Krow]

9 hours ago, jimmyb625 said:

That's the same setup I used to have (except for the 310's). It's a great rig for the price.

I eventually got hold of a 315s as there was a b-stock item going for a ridiculous price (£120 off the top of my head). It's good, but definitely not as easy to move around as the 312s.

 

We've got a sub on our wish list now that we've got a band member who is able to store and transport it!

 

I appreciate a single 15" sub is usually considered inferior to two 12". But did you notice a significant improvement of the 15" over a single 12"?

[synthaside]

On 22/12/2025 at 13:31, Chienmortbb said:

 I have found the circuit diagram for this speaker, and it uses fairly conventional analogue circuitry.  It is not a high-powered speaker, using three LM3886 amplifier chips, two for the LF and one for the HF. I have to say that Mackie run this chip very close to its maximum voltage unless the LF speaker is 16 ohms. Happy to have a look at it if you like. IMHO, useful as a monitor, but not FOH. 

Thank you for the offer but I ended up taking it to the recycling centre on the clean up for Xmas , I felt bad but its been recycled at least....  we're using the surviving one as a side fill as it's got a smaller footprint than our current wedges.