Double bass rebuild - not for the faint of heart!

[The Guitar Weasel]

Neck fit is getting closer - this is all hand tools shaping so it can't be rushed. Looking a bit rasp-rough at the moment ... but lots more wood to come off still. 

 

One issue that has been highlighted is how bodged the previous neck re-glue was and how 'out' the original neck pocket was built. I wondered why the neck appeared to have been glued in without being fully seated in the pocket - in other words glued to the sides but not even touching in a lot of the bottom of the pocket. Well that would appear to have been a bodged attempt to face the neck properly down the centre line of the body. with the new neck properly seated and its mating face at exactly 90 degrees in all directions the neck and the fingerboard (strapped on with tape for the test) point way too far over to the bass side f hole. The whole neck pocket must be out of true with the centre line. The solution is to plane and use a cabinet scraper to deliberately take the back of the heel down on one side - thus pointing the neck/fingerboard once more along the centre line. 

 

 

 

For those into tools - the lion's share of the wood stock removal on this project has been done with the 'rip' side of a 250mm Japanese Ryoba hand saw. I really can't speak highly enough about how good these saws are. Maple is hard - and a bitch to hand saw - but not with one of these. The Ryoba cuts like a sharp breadknife through a fresh sourdough loaf ... so satisfying. 

Edited 10 hours ago by The Guitar Weasel