What’s wrong here? Pickup noise

[Duroc17]

Can’t see any loose wires but the bottom part of the pickup is making a grounding noise when touched but not the top bit. I’m getting some low end break up when played

 

if i touch the white wire from pickup to  volume I get the earth sound 

 

appreciate any tips. Have to say electrics are not my strong point 

 

 

[tauzero]

The most obvious answer is that the wires from the pickup that buzzes are reversed, so the ground side is connected to where the hot side should be. If the connection to the pickup is through solder pads on the bottom of the pickup, just unsolder them at the solder pads and reverse the wires.

[Bigguy2017]

19 hours ago, tauzero said:

The most obvious answer is that the wires from the pickup that buzzes are reversed, so the ground side is connected to where the hot side should be. If the connection to the pickup is through solder pads on the bottom of the pickup, just unsolder them at the solder pads and reverse the wires.

???  Pickups will then be out of phase?

P pickups are wired RWRP.

It's pssible/probable (?) the two coils are wound the same direction and simply reversed for one half, with flipped magnets. IF so one coil will be 'hot end out' and one 'earth end out' rather than wound CW and CCW. That could explain the noise.

Check the magnets' polarity (with a DVM and an allen key) - each PuP half should be opposite polarity, and coils should be opposite wind.

 

It can help to ground the pole pieces - one each PuP stick a strip of conductive copper tape along the underside of the pole pieces and connect to the cold terminal.

 

 

[Duroc17]

4 minutes ago, Bigguy2017 said:

???  Pickups will then be out of phase?

P pickups are wired RWRP.

It's pssible/probable (?) the two coils are wound the same direction and simply reversed for one half, with flipped magnets. IF so one coil will be 'hot end out' and one 'earth end out' rather than wound CW and CCW. That could explain the noise.

Check the magnets' polarity (with a DVM and an allen key) - each PuP half should be opposite polarity, and coils should be opposite wind.

 

It can help to ground the pole pieces - one each PuP stick a strip of conductive copper tape along the underside of the pole pieces and connect to the cold terminal.

 

 

Taking it to mr fixer. He thinks the base plate isn’t earthed properly but that’s a guess from pics. Will know tomorrow night and report back