LED lighting.

[Chienmortbb]

On 21/09/2025 at 16:43, Chienmortbb said:

The remote had a spare battery and that also did not work.

 

I connected the light to my DMX controller and it works fine. I had to re-learn DMX too, as I had forgotten that the addresses go up in 16s. 

Doh. I was complaining about the lack of a DMX on the wall washer. The clue is RGB. Once you have the address set, the faders 1,2 and 3 on the controller control the Red Green and Blue LEDs. Doh

[Stub Mandrel]

26 minutes ago, Chienmortbb said:

Doh. I was complaining about the lack of a DMX on the wall washer. The clue is RGB. Once you have the address set, the faders 1,2 and 3 on the controller control the Red Green and Blue LEDs. Doh

 

It's a shame they don't standardise on the first five channels of every light being overall brightness/r/g/b/w.

[TimR]

I mentioned this in the DMX thread.

 

Although I have 4 par cans that are 4 chanel so I can run all 4 off two pages of faders by setting adresses to 1, 5, 9 and 13.

 

My mini spots are 5 chanel? Go Figure. To keep the desk simple I program 1, 9, 1, 9. Losing about 12 channels, but I don't have hundreds of fixtures and multiple universes. 

 

This is where software comes in handy. 

 

Useful to have a cheat sheet printed referencing each page, fixture and what chanels you're using. In case you want to alter lights on the fly instead of using programmed scenes. Essential when programming anyway. 

Edited 1 hour ago by TimR

[TimR]

1 hour ago, Al Krow said:

I've always really liked these guys' lighting set up for a 3/4 piece band:

 

 

https://www.instagram.com/reel/DR7JilxjEMB/?utm_source=ig_web_copy_link&igsh=MzRlODBiNWFlZA==

 

The static wash they use at every gig looks good. 

[Stub Mandrel]

54 minutes ago, TimR said:

I mentioned this in the DMX thread.

 

Although I have 4 par cans that are 4 chanel so I can run all 4 off two pages of faders by setting adresses to 1, 5, 9 and 13.

 

My mini spots are 5 chanel? Go Figure. To keep the desk simple I program 1, 9, 1, 9. Losing about 12 channels, but I don't have hundreds of fixtures and multiple universes. 

 

This is where software comes in handy. 

 

Useful to have a cheat sheet printed referencing each page, fixture and what chanels you're using. In case you want to alter lights on the fly instead of using programmed scenes. Essential when programming anyway. 

 

I figured out my PARS will be happy with 1,9,17,25 etc. But means page switching when programming them.