short right angle to right angle 9v

[MuddBass]

Hi

 

For pedal board linking power from my peterson tuner to power another pedal, I need a very short one of these.... ideally 8 to 10cm

 

Must be right angle to right angle

 

https://www.amazon.co.uk/PPBAR-R36-2-1mm-Right-Angle-Barrel/dp/B00WBSMC0K

 

I'd really appreciate if you could pop any links etc below.

 

Thanks

[MuddBass]

This EBS is close, but a little too long:

 

https://www.gak.co.uk/en/ebs-dc1-18-90-90-1-to-1-power-distribution-angled-cable-18cm/931887

 

 

[MartinB]

Rockboard do a 15cm one: https://www.rockboard.de/en/power-supplies/power-cables/power-cable-angled-angled/

[MartinB]

Shorter than that, you may need to do it yourself: https://www.pedalpatch.co.uk/product-page/solderless-dc-kit-v2

[MuddBass]

Thanks for sending those links - much appreciated

[Downunderwonder]

If you are handy with a soldering iron it's pretty easy to make a power cable shorter.

 

Snip out an over lay ie opposing short and long tails, and then trim overall length to suit. Don't forget your heat shrink.

 

Doing it overlayed makes for only one piece of heat shrink required and a nice neat job.

[tauzero]

I've been making up some shorter power cables for one pedalboard. Because of the relative positions of power supply and pedals, I needed some right-angle to right-angle and others straight to right-angle, so I cut a few of the leads supplied with the power supply to length and soldered the appropriate half to one of these: https://www.ebay.co.uk/itm/261536704983?var=560412003886 which is a lot easier than splicing wires together. Just don't forget to put the O-ring that holds the plug together onto the lead before soldering the plug on.

[MuddBass]

Thanks everyone. Some good ideas there. Much appreciated.