Jump to content
Why become a member? ×

MuddBass

⭐Supporting Member⭐
  • Posts

    470
  • Joined

  • Last visited

Everything posted by MuddBass

  1. Looks great and highly portable. I too use a cahon bag similarly, really easy setup and pack down too!
  2. Reduced: Was £125 posted in the UK / £120 collected from Winchester, SO53. NOW £115 posted in the UK / £110 collected from Winchester, SO53.
  3. JAM Delay Llama Mk2 £150.00 REDUCED TO £135 REDUCED AGAIN - NOW £100
  4. I'd say no, it's far too quiet for that in my experience.
  5. Hi Richard I use one, and you're more than welcome to try mine if you like - I am Hampshire based. It won't add to your overall volume, rather adds to clarity of note. Positioning is key, and I use a mic stand to get nearer my head height. For me, I don't really notice it when it's on, but seem to notice it when I don't use it. Hope this helps, Greg
  6. Hi Steve. Yes, still here. Do feel free to send me a quick message if you would like them. Cheers, Greg
  7. REDUCED MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case (mainly home use only - unmarked) NOW: £795 MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case - (several gigs but well looked after and unmarked) NOW: £730 BCS Manufacturing custom Full Flight Case with heavy-duty castors etc to suit (1) 2x10 bass cab (light use only - unmarked) NOW: £220 (can be posted for £30 if needed)
  8. Thanks everyone. Some good ideas there. Much appreciated.
  9. Thanks for sending those links - much appreciated
  10. This EBS is close, but a little too long: https://www.gak.co.uk/en/ebs-dc1-18-90-90-1-to-1-power-distribution-angled-cable-18cm/931887
  11. Hi For pedal board linking power from my peterson tuner to power another pedal, I need a very short one of these.... ideally 8 to 10cm Must be right angle to right angle https://www.amazon.co.uk/PPBAR-R36-2-1mm-Right-Angle-Barrel/dp/B00WBSMC0K I'd really appreciate if you could pop any links etc below. Thanks
  12. Loop now sold, just the JAM Delay Llama Mk2 pedal left.
  13. Seymour Duncan Studio Bass Compressor. REDUCED Was £125 posted in the UK / £120 collected from Winchester, SO53. NOW £115 posted in the UK / £110 collected from Winchester, SO53. Dual lock tape on bottom (like velcro). Specifications (as per GAK website) https://www.gak.co.uk/en/seymour-duncan-studio-bass-compressor/108834?gclsrc=aw.ds&&gclid=Cj0KCQjwhfipBhCqARIsAH9msbkCmjGIwqwvOsaPjEXgYb11Gd6y8N4SEcmdpIJM5DoPFKghccTVEdQaAo0mEALw_wcB Compression Ratio: Soft-knee, adjustable from 1:1 to > 20:1 Maximum Compressor Gain: 33dB Attack Speed: Adjustable from 8ms to 27ms Input Impedance: 1 Megohm Output Impedance: 2.75K ohms maximum Maximum Input Level: 3 Vrms Distortion: < 0.3% at 300mV RMS output at 1 kHz Noise referred to Input: -110dBV, 400 Hz - 20 kHz, input shorted Compressor Type: Voltage Controlled Amplifier (VCA) Power: 9V battery or 9V to 18 Vdc regulated adapter, center pin negative polarity Current Consumption: 21mA operate, 19mA bypass Dimensions: 2.60" wide X 5.0" long X 1.45" high Weight: 0.67 lbs. Seymour Duncan Studio Bass Compressor Pedal Overview The Seymour Duncan Studio Bass Compressor has been made for bassists looking for a compressor that increases sustain, accentuates picking and can evens out fast runs. Its simple layout means anyone can use the Studio Bass Compressor: The Blend knob lets you to adjust the amount of wet signal allowing natural "snap" back into your individual notes. The Volume knob controls the output, the Attack regulates how fast the compressor responds to picking and plucking and the Compressor knob controls the dynamic range. The Low/Full/Mid switch determines the frequency content of the dry signal being blended in with the compressed signal so you can bring back your dynamic range. This stops your bass from sounding over-compressed. This is a massively versatile pedal that is suitable for players across a range of styles. Seymour Duncan has a fully comprehensive list of suggested settings for different genres and sounds.
  14. For sale: MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case (mainly home use only - unmarked) £870 MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case - (several gigs but well looked after and unmarked) £800 BCS Manufacturing custom Full Flight Case with heavy-duty castors etc to suit (1) 2x10 bass cab (light use only - unmarked) £270 (can be posted for £30 if needed) REDUCED MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case (mainly home use only - unmarked) NOW: £795 MESA Engineering Subway 2x10 Diagonal Bass Cab Ultra-Light with Mesa soft-case - (several gigs but well looked after and unmarked) NOW: £730 BCS Manufacturing custom Full Flight Case with heavy-duty castors etc to suit (1) 2x10 bass cab (light use only - unmarked) NOW: £220 (can be posted for £30 if needed) Ideally would like to sell all together, but would consider splitting. Collection only for the cabs - I am based between Winchester and Southampton Any test welcome with heads available for you to use including Laney, Mesa, Quilter, Eden etc (or bring your own head to try!)
  15. Any links for spare bass ukulele machine heads please. Ideally only need one (black, A String). It's off a Harley Benton bass, but I can't seem to see spares via Thomann.
  16. The Ampeg Venture look interesting, and the blend (wet/dry) effects loop is a nice touch at this price point. It seems a shame that they don't offer a variable HPF like Mesa have done. Does anyone know where the Ampeg Venture Heads are assembled?
  17. Updated - Palmer DI and Future Impact sold. Looper and Delay still available.
×
×
  • Create New...