bagsieblue

Sue Ryder P Bass - £69 Shipped Mainland UK Sue Ryder bass, in red/rosewood. If you haven't heard of Sue Ryder basses before then, there’s a fair bit of info around on these basses in these parts. Obviously it's not the greatest P in the world, but it's certainly a decent enough bass. Scratch plate screws are non-original, one of the ferrules on the back from through body stringing is missing. Knobs have been replaced with brass coloured versions. Apart for that, it's all as it should be and costs less than £100!! I'll probably take the neck off for shipping to make it more cost effective on a relatively lower value bass. Located in Chorley Lancs.

I'm based in Chorley, Lancs. Bass weights 3.478Kg

Zon Sonus 4/1 Bass Guitar - Rare Colour - Graphite Neck. NOW £999 shipped Mainland UK - No Trades. Up for sale is my Zon Sonus 4 string, 24 fret phenowood/graphite neck, in what I believe is a rare custom colour. In good overall condition as can be seen from the photographs. The odd scuff/scrape but nothing that affects playability. However, note that a previous owner has drilled point right through the headstock in previously installing a drop D tuner therefore close to the E string machinehead there is a tiny about 2mm in diameter. The Zon Sonus 4/1 spec is: Neck Type: Composite, bolt-on design Scale length: 34" Finish: Flat urethane Fingerboard: Phenowood w/side dot markers Radius: 12" Nut: Graphite Frets/size: 4-string: 24/medium Width at nut: 4-string: 1.532" Width at 24th fret: 4-string: 2.437" Electronics Type: ZB2 active system by Bartolini. Functions: Master volume with stacked bass/treble control. Boost/cut +/15dB. Power requirements: Single 9-volt battery Life expectancy: 2500 hours of continuous use. Pickup: Make: Exclusively designed for Zon by Duncan custom shop. Type: Wide aperture, passive, dual coil design. Soapbar style shell. I'm based in Chorley, Lancs.

Yes

I'm open to possibly parting out the body and neck if that helps?

Now Sold Pending..

More photos added as requested.

BUMP

Now £360 plus £15 to ship Mainland UK - No Trades.

I'm not familiar with that bass - it would be your call if it fitted your bass.

Bump

Now £370 plus £15 to ship Mainland UK - No Trades.

I'm not familiar with that bass - it would be your call if it fitted your bass. I can supply instructions.

Now £399 plus £15 to ship Mainland UK

NOW SOLD

BUMP

Still Available...

Chorley, Lancs.

GK Gallien Kruger MB800 Amp Now £360 plus £15 to ship Mainland UK - No Trades. Clearing Out A Lot of Gear: GK MB800 Amp. Great Amp, all works as it should. Continuing the evolution of the MB Series, the MB800 bass amp head from Gallien-Kreuger features incredible output, increased functionality, and a completely discreet FET-driven preamp. With 800 massive "GK watts" of power, the MB800 can handle even the largest venues without breaking a sweat, and at 5 lb., neither will your roadie! All of the MB800's controls are lit to indicate the current operating status, including input clip, tuning mute, Gain A, Gain B/Level-B, power amp clipping, limiter enable, and EQ/Contour settings. The same FET technology used to create the legendary boost (G.I.V.E.) circuit found in all GK amplifiers for over 30 years is used in every stage of the MB800 preamp. Using FET devices to drive the GK four-band active EQ, Contour, and Gain allows the MB800 to transition seamlessly from a full, warm, clean tone to full-on GK growl. FEATURES 800W @ 4 ohms, 500W @ 8 ohms Discreet FET preamp Push-activated Gain A/B and limiter defeat -10dB pad 4-band active EQ with variable contour Effects loop and tuner mute XLR out, pre/post EQ Defeatable limiter Two Speakon outputs Headphone/line output

New Pics Added.......

Up for sale is my - Fender Precision Bitsa It's an: American Special Body with the usual pickups found in this model and the original loom. A 3rd party chunky bridge, think of it as halfway between the mass of a Stock Fender and a Badass. A vintage style neck plate. The neck is a Mexican Jazz , left handed neck so, giving a Reverse HeadStock when strung right handed. Fret markers have been added to the top (underside if left handed) to aid navigation - these appear to be a painted on and look fairly convincing and do just the job. The body is in great condition - a few scuffs here and there. The neck is in good condition, however there is a little delamination of the skunk stripe on the back of the neck. All in all this is a nice playing, precision that sounds like a good precision should. Bass weighs just over 4KG at 4034g.

A great bass in great condition, just a couple of areas where the finish is through to the wood - as shown in the photographs. Pretty good condition actually given the age of the bass. The bass has been used but not abused. A very versatile, classic bass. Here is the description from Yamaha: The 4-string TRB4II is a serious low-end machine with a rosewood-on-maple neck, finely sculpted ash body, smoothly ergonomic cutaway and neck joint, and bottom-anchoring brass bridge. Our 1998 refinements include a pair of beefy humbuckers, 35" scale length, and active electronics with surgically accurate three-band EQ. The spec is: Scale length: 35: Neck: Bolt-on Length: 1160 mm (45.66") Width: 354.3 mm (13.95") Body: Ash Fingerboard: 24 fret Rosewood, Hardware: Gold plated Nut: Bone Pickups - Yamaha Alnico Preamp - Yamaha 3 band I'm based in Chorley, Lancs, any trial or inspection is welcome.

This is a Fretless Bass Built from a Made In German Streamer Standard Body with a Warwick Rock Bass Neck. Has upgraded bridge hardwear (the German Streamer Std came with a Fender style bridge originally) Active / Passive Switch, the other switch switches the mids on the active pre amp. Great active pre amp an Aguilar OBP 3 which is worth approx £150 alone. Given it's a 'bitsa' build, I'd much prefer collection only as I'd much prefer that this was tested by a buyer. That said, courier may be possible so please contact me. I'm based in Chorley, Lancs, any trial or inspection is welcome £350 Collected. No Trades please.