Changing/adjusting overly-bright LEDs in pedals?

[AinsleyWalker]

I've had a MuTron MicroTron IV on my board for years, it's great but I've finally had enough of the stupidly bright LEDs.
Anyone know anything about replacing/adjusting LEDs? Thought I'd ask here before I go back to work and can ask some technicians.

And Happy New Year 👍

 

Edited 2 hours ago by AinsleyWalker

[SimonK]

My keeley compressor has a similar problem (also blue) so I've put some masking tape over the LED. You can still see when it is on, but can also make out the settings. Otherwise simply open it up and solder on a different LED?

[AinsleyWalker]

9 minutes ago, SimonK said:

My keeley compressor has a similar problem (also blue) so I've put some masking tape over the LED. You can still see when it is on, but can also make out the settings. Otherwise simply open it up and solder on a different LED?

 

Yeah I may get some replacement LEDs, if that's the easiest solution (other than tape etc). I wasn't sure if they could be internally adjusted.

 

Will do some reading into what kind/rating etc LED will be best. 

Edited 2 hours ago by AinsleyWalker

[Geek99]

Just use tape - add layers till you get the desired effect