iamtheelvy Posted November 20, 2022 Share Posted November 20, 2022 Just trying to figure out if there’s a simple one-box solution to my setup… At our gigs I’m running bass guitar and synth side by side. We’re not a big band, so no money (or roadies to carry) a big rig, so i’d like to be able to run both instruments through my one amp, but send separate DI signals to the PA. Bass normally runs through the amp, and the synth through the PA and monitors, but I really struggle to get enough volume from the synth to match my amp. I could run two DI boxes into a mixer/blender pedal of some sort, but was wondering if there was an easier way to set this up? Any stereo DIs that will do the mixing job too? Was looking at the Walrus Audio Canvas stereo but can’t seem to find out if the Sum switch affects the DI outputs also… (https://www.walrusaudio.com/products/canvas-stereo-dual-line-isolator-d-i?variant=42416441688299) Quote Link to comment Share on other sites More sharing options...
tayste_2000 Posted November 20, 2022 Share Posted November 20, 2022 Most radial DI’s do this, including the low cost stagebugs, but they use the thru to do it. Else a Boss LS-2 will do what you need. 1 Quote Link to comment Share on other sites More sharing options...
Phil Starr Posted November 20, 2022 Share Posted November 20, 2022 If you want to keep cost down then using a simple mixer might be a solution https://www.thomann.de/gb/behringer_xenyx_1002.htm You could pan the two instruments left and right and send them separately to the PA and then use the mono aux send to connect to your amp. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.