4-Pos/3-Pole Rotary Switch for two pickup wiring

[Immo]

I'm looking to ditch the Jazz-style wiring on my P+P bass, because it doesn't work the way it should, rolling down one volume essentially makes its pickup inaudible anyway. I want to swap one pot to a 4-position rotary switch that will enable switching between: Neck PU only, both PUs in Parallel, both PUs in Series, Bridge pickup only.

I searched online and can't seem to find a wiring diagram nor a thread on forum/Reddit/etc. that understands that mission, and I could've sworn that before the search engines suffered a major episode of enpoopification, the diagram WAS there.

Anyway, I made a crude diagram myself and just want to make sure it's legit. My ADHD brain sometimes just won't cooperate with such focused tasks. Any help and feedback would be appreciated.

  

 

Edited 5 hours ago by Immo
Cleaned the pic

[Mediocre Polymath]

I've done exactly this on a few guitars. I'm not near my computer, but I have diagrams somewhere. I'll have a look in the morning.

[Immo]

2 minutes ago, Mediocre Polymath said:

I've done exactly this on a few guitars. I'm not near my computer, but I have diagrams somewhere. I'll have a look in the morning.

This would be much appreciated.

[Mediocre Polymath]

Aha. Found it. I had a copy buried in my photos folder for some reason.

[Immo]

1 hour ago, Mediocre Polymath said:

Aha. Found it. I had a copy buried in my photos folder for some reason.

Looks the same, just w/ swapped pickups and one Hot output being soldered to output terminals instead of the inner pole (A). Is there any practical difference?