Lacquer peel repair?

[BasistaFunky]

Hello there everyone, can you please tell me how to repair this lacquer peel?

[Silky999]

Is it poly or nitro? If it nitro, then sand and feather the edges with 600-800 grit and respray, the nitro will melt into the existing layers and you will be able to wet sand and spray until you get a flat finish. It’s similar to blending in a water slide decal on a headstock under nitro clear coat. 
 

If it’s poly, it’s much more of a nightmare as poly does not melt into the previous coats and whatever you do you are likely to get witness marks where the old and new coats overlap. I had similar where I slipped installing a tuner and scratched a headstock, it was impossible to get it to blend. I had spent ages spraying and sanding back over my logo so couldn’t face stripping and starting again so I sold the bass with money off. I vowed never to use poly instead of nitro again. 
 

If you do go blending poly route, it’s a similar process to the nitro. The area appears too large to use CA glue to fill. If Poly, I would be inclined to consider a neck plate to cover most of the obvious part of the repair.

 

You could consider a full strip and refinish if it is a precious bass but it would need to be repainted and then clear coated due to the impossibility of stripping the poly without damaging the paint layer. 

Edited August 29 by Silky999