Funky Dave

Still selling

Up! Price update: 500 GBP + shipping

Up

80`s BURNS Bass (Made in Japan, Neck-through), £550 Hello! I sell a extremly rare BURNS Bass (Made in Japan, Neck-through). Made in Morridiara Factory, Japan. Sometimes these instruments appear under "Morris Global Sound" trademark. Body design similar to early Alembic/J&D bases. Very rare model, not possible to find similar bass in web. Built in in early 80`ties, no serial. In good condition, few scratches on body. Very good sustain and unique vintage tone. Absolutelly NO any hum or noise in headphones in active and passive mode. Neck: Neck-through, 5-piece walnut/flamed maple Body: 2 alder body with walnut top/bottom. Weight less than 4 kg. 34” scale. Brass nut. 20 frets. Frets are 30-40% wear remaining. String spacing bridge about 18.5-19 mm. It is Warvick bridge, and it is possible to adjust spacing/height depending on your needs. Original pickups and pots was replaced by luther with new: Pickups: Seymour Duncan Passive Soapbar set SSB-4s (ceramic magnets): https://www.seymourduncan.com/pickup/passive-soapbar-set-phase-ii?__uuid_ref=5bb5e210995e4?__uuid_ref=5bb5e21099628 Preamp: Glockenklang 3 band EQ, active/passive switching by push/pull volume pot. https://www.glockenklang.de/en/products/products_bass.htm This instument is very good for recording as well as live! Instrument comes with big hardcase. Located in Riga, Latvia. Shipping to EU/UK without problem. Price: £550 (shipping included).

Thank, you for information and catalogue page! I have seen similar Hohner (but with other logo on headstock). Maybe you are right, no any common with "Burns UK". I buy this bass with this logo, and maybe some one put personally. About hardware: i have original electronics (pots, jack) and bridge (with little rust). Pickups was single coil (in a humbucker frame) and was unfunctional. I`am not shure that that was original pickups of the bass. regards, Denis

80`s BURNS Bass (Made in Japan, Neck-through), £550 I selling a extremly rare BURNS Bass (Made in Japan). Made in Morridiara Factory, Japan. Sometimes these instruments appear under "Morris Global Sound" trademark. Body design similar to early Alembic /J&D bases. Very rare model, not possible to find similar bass in web. Built in in early 80`ties, no serial. In good condition, few scratches on body. Very amazing sustain on all strings and unique vintage tone. Absolutelly NO any hum or noise in headphones in active and passive mode. This instument is very good for recording as well as live! Neck: Neck-through, 5-piece walnut/flamed maple Fretboard: Rosewood with pearl ovals Body: alder body with walnut top/bottom. Weight: less than 4 kg. Scale: 34” Brass nut (top). 20 frets. Frets are 30-40% wear remaining. String spacing at bridge: 18.5-19 mm. Instrument equiped with new two piece Warvick bridge, and it is possible to adjust string spacing/bridge height depending on your needs. Original single coil pickups, pots and bridge was replaced by luther with new humbucker PU and preamp: Pickups: Seymour Duncan Passive Soapbar set SSB-4s (ceramic magnets): https://www.seymourduncan.com/pickup/passive-soapbar-set-phase-ii?__uuid_ref=5bb5e210995e4?__uuid_ref=5bb5e21099628 Preamp: Glockenklang 3 band EQ, active/passive switching by push/pull volume pot. Volume (passive/active mode push-pull) / Balance / Treble /Middle /Bass controls https://www.glockenklang.de/en/products/products_bass.htm Instrument comes with big wooden hardcase. Instgument will be profesiionally packed for shipping. Located in Riga, Latvia. Shipping to EU/UK without problem. Price: £550 + shipping, depending of destination.