The NW and Scotland Bass Bash and Petting Zoo 2026 - Saturday April 25th Confirmed

[rwillett]

Nein

[rwillett]

I was planning to do an hour or so talk about 3d design and 3d printing at the Bash. A few people have expressed a slight interest. For those of you who remember the village hall in Clapham, there is a little room adjacent to the kitchen, and I would use that.

 

Is this of interest to other people? If so, what would people like to know about? I can't design and print a bass in an hour but I can talk through the basics and explain what works and what doesn't. It's easy enough to bring a 3d printer over and I can make the session interactive. Perhaps show how to design a simple pickup cover, or a volume control or something. 

 

Just throwing this out there for feedback and comments (good and bad).

 

Thanks

 

Rob