Dan C

Thanks for all the advice! Will past it along.

Hi all, helping a friend fix a bit of a bodged pickup job on an upright he's recently purchased. It came with a piezo squeezed in on the E/A side of the bridge, the usual spot it's added in from what I can tell... but whoever installed it didn't sand the gap completely flat so it doesn't sit fully snug or in contact properly. You can wiggle it a bit if you want. Is there an easy fix for this that doesn't involve removing the bridge and replacing it? Any piezo pickup suggestions? It's for 50s playing, nothing too slappy so he doesn't want to go the fingerboard mic route. Just the bridge is sufficient, but he just want's it a little more secure and hopefully improve the sound at the same time!