Jump to content
Why become a member? ×

Tweeter advice sought.


B.Flat
 Share

Recommended Posts

Hi.

So, I have a 2 X 10" cab (which is really two 1 X 10's", as the internal space is divided) to which I would like to add a high frequency driver.

The advice I am looking for is, which driver (the 10" are Deltalite 2510's) which needs to be as small as possible as space on the baffle is tight,  and which x-over (off the peg if possible but would build one if not too difficult). Is the tuning of the cab important regarding this x-over ?

The cab is driven by one side of a Yamaha PX 3 power amp, 500w at 4ohms

 

Link to comment
Share on other sites

I'd be very careful with this if I were you, @B.Flat. There's a very good chance that the lowpass circuit Bill has suggested will drop the impedance of your speaker to 2.5 ohms. Your Yamaha is 2-ohm stable - so you should be all right. However, you should be aware that the circuit will probably also induce a nasty peak at 2kHz, which won't be very nice. Just sayin'.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...