SOLD....PLEASE DELETE. Ash Body project cut but unfinished £75 posted UK £75 NW Hampshire

[mybass]

Now Sold

I will put £75 on this including UK postage. This is a little less than the wood cost from Europe.

A nice looking one piece body of Ash wood, bit of 'olive ash' in it, from an old project. Its been wet sanded since so needs more Tru Oil or just sand it all back again for whichever finish needed. I was initially making this for a narrow neck I'd made up so the neck slot will need routing for extra width if necessary. The backplate has magnets holding it in place. The jazz pickup slots are angled and of 'standard' differing widths holes at about 96mm bridge and 94mm neck, (Delano pups were to be used). This neck slot is only 57mm at its widest so enough there to widen. I think I was fitting a Hipshot A style bridge for this. No control holes so thats all open for your own configuration.

Lightweight at  close to 4lb 10oz / 2kg+60grams

Sizes approx 20" / 510mm long........12.5" / 315mm wide......thick just under 1.5" / 38mm

The neck 'eyelets' are the 14mm width ones.

Edited July 13, 2019 by mybass

[mojobass]

Is this for 21 or 24 fret neck?

[mybass]

24 originally.