Jump to content

Glockenklang BassArt + Bugatti 120 - ON HOLD !!
£1050


funkydario
 Share

Recommended Posts

I am playing only in-ear monitor lately so the "beast" need To go. Recently cleaned up and change the speaker out with speakon. The preamp do not need presentation and the pwr amp pump out 240w/8 ohm bridged...very loud.

I am asking 1200€ shipped.

 

20180131_170810.jpg

20180131_170727.jpg

Edited by funkydario
Link to comment
Share on other sites

  • 2 weeks later...
  • 2 weeks later...
1 hour ago, sifi2112 said:

How do you ‘bridge’ the two channels ?

From the manual...

...


5.1 Mono Bridged Mode In bridged mode use the left XLR-female input and connect the XLR-male beneath it with a crosscable to the XLR-female input of the other channel. At the crosscable pins 2 and 3 at the male plug are changed to 3 and 2 of the female plug, which results in a phase switching at the second channel. The speaker is connected to the red binding posts, whereas the speaker+ is at the left channels post and the speaker – at the right channels post. Both black binding posts have to be connected by a 4 qmm cable.Attention: In bridged mode the minimum impedance is 8 ohms!
...

Having no binding posts, a suitable-cabled 'bridge-mode' Speakon cable would have to be used with this model.
Hope this helps.

Link to comment
Share on other sites

Not quite sure if a standard male to female xlr bridges the preamp ..?

And regarding the speakon outs, do they need a Y split speaker cable with just the ‘+’ wired on both left & right channel speakon out then going to standard ‘+/-‘ speakon to 8 Ohm cab ..?

Link to comment
Share on other sites

3 hours ago, sifi2112 said:

Not quite sure if a standard male to female xlr bridges the preamp ..?...

No, it's a crosscable that's required...

...the crosscable pins 2 and 3 at the male plug are changed to 3 and 2 of the female plug, which results in a phase switching at the second channel...

3 hours ago, sifi2112 said:

...a Y split speaker cable with just the ‘+’ wired on both left & right channel speakon out then going to standard ‘+/-‘ speakon to 8 Ohm cab ..?

That is correct.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...